iFlight Beast F7 55A AIO Flight Controller Board FPV F7 AIO Board 25.5x25.5 Mounting for Cinewhoop Quadcopter Drone like Protek35

Description

This fits your .

Top Features:
Vista digital system Plug-and-Play (VBAT passthrough)
MCU: BGA-STM32F745, 216MHz
OSD: AT7456E

Blackbox: 16Mb Onboard Flash
BEC output: 5V 2.5A
Barometer: no
 
Safety reminder:
The fpv air unit plug&play port has no voltage regulator (BEC) and is passing through VBAT.
The Vista goes up to 26.4V (6S), the Air Unit goes up to 17.6V (4S).
Make sure not to plug-in your Air Unit directly when you're flying 6S, because this would fry it!
BEC to add for your 6S build can be found on amazon,please search: "iFlight BEC 5V 3A / 12V 2A".

Small motor 4S builds should usually need an additional capacitor of at least 16V/220uF, for 6S go up to 35V or even 50V.
Bigger motors have a bigger current draw, higher voltage spikes and more serious back EMF (motor braking, works like a generator).
Make sure to add big enough or even bigger low ESR capacitors on the AIO battery pad or on your battery lead the more aggressive motors you fly.
 
FC Beast F7 AIO
SPECS:
MCU: BGA-STM32F745

Blackbox: 16Mb Onboard Flash
BEC output: 5V 2.5A 
Barometer: BMP280
Connector: Micro-USB
OSD: AT7456E
FC Firmware：IFLIGHT_F745_AIO V2 
Mounting pattern: 25.5*25.5mm φ3mm
Dimensions: 32.5*32.5mm
Weight: 8.9g
 
ESC 55A 2-6S
SPECS:
Uarts: 5
Current Sensor: Yes
Input: 2-6S LIPO
Current scale: 200
Constant: 55A / Burst: 60A
BLHeli: BLHeli-S
Telemetry: no
ESC Firmware: G-H-30 BLS
 
Pack list:
Beast F7 AIO x 1
Capacitor 470uF/35V x 2
XT60 14AWG cable x 1
XT30U 18AWG cable x 1
1.0-7P cable 50mm-28mm x 1
1.0-7P cable x 1
M2 silicon grommets x 4
M2*12mm screws x 8
M2 Transparent Nylon Nut x 8
0.8mm black Heat shrink tube x 8

iFlight Beast F7 55A AIO Flight Controller Board FPV F7 AIO Board 25.5x25.5 Mounting for Cinewhoop Quadcopter Drone like Protek35